KEB Combivert F5 Instruction Manual page 58

Parameter description
LA.06 AN1 Offset Y
Value range
0,0...±100,0 %
LA.07 AN1 lower limit
LA.08 AN1 upper limit
Value range
0,0...±400,0
Limitation of the analog
LA.09 AN2 setpoint selection
Input
0
1
2
LA.10 AN2 interference filter
Input
0
1
2
3
4
LA.11 AN2 zero point hysteresis
Value range
0...±10 %
LA.12 AN2 amplification
Value range
0,00...±20,00
GB - 58
Setting Description
0,0 % This parameter shifts the input characteristic on the Y-axis.
Setting Description
LA.07 The parameter serves for the limitation of the analog signal AN1 after the
-400,0 amplifier stage. As no interacting locking exists, it must be observed, that the
lower limit is adjusted smaller than the upper limit. (Exception F5-M: In case
LA.08 of lower limit > upper limit then output value = lower limit).
+400,0
Fig. LA.07/08:
input signal AN1
Setting Signal
x 0...±10 V
0...±20 mA
4...20 mA
Setting Average
from
x none
2 values
4 values
8 values
16 values
Setting Description
0,2 % see LA.03
Setting Description
1,00 see LA.04
LA.07/LA.16
-400%
LA.08/LA.15
Depending on the setting the analog input can process the listed
setpoint signals.
value
A query of the analog signal takes place every millisecond. The
interference filter shall suppress interferences and ripples of the
input signal, by forming the average value from 2, 4, 8 or 16
scanned values for further processing.
400%
400%
-400%
Description
Description