Plugging And Removal Of The Components - WAGO I/O System 750 Series Manual

2.6.5 Plugging and Removal of the Components

Warning
Before work is done on the components, the voltage supply must be turned
off.
In order to safeguard the ECO coupler from jamming, it should be fixed onto
the carrier rail with the locking disc. To do so, push on the upper groove of the
locking disc using a screwdriver.
To pull out the ECO fieldbus coupler, release the locking disc by pressing on
the bottom groove with a screwdriver and then pulling the orange colored
unlocking lug.
Fig. 2-5: Coupler and unlocking lug
It is also possible to release an individual I/O module from the unit by pulling
an unlocking lug.
Fig. 2-6: removing bus terminal
Danger
Ensure that an interruption of the PE will not result in a condition which
could endanger a person or equipment!
For planning the ring feeding of the ground wire, please see chapter 2.6.3.
WAGO-I/O-SYSTEM 750
DeviceNet
The WAGO-I/O-SYSTEM 750
Mechanical Setup
• 21
g0xxx18e
p0xxx01x