WAGO I/O System 750 Series Manual page 94

94 • DeviceNet
Configuration / Parametering with the Object Model
50
51
Services:
Service Code
0x0E
0x10
4.6.2.1.9 Discrete Input Point Object (0x65):
Instance 0:
Attribute
ID
1
2
Description of the instances:
Instance ID
1
2
...
255
Instance 1 to 255:
Attribute
ID
1
Services:
Service Code
0x0E
specific get/set reserved
specific get/set BK_FBC_CF
G
Service Name
Get_Attribute_Single
Set_Attribute_Single
Used in Access Name
buscoupler rule
required get Revision
optional get Max
instance
Description
Reference to the first digital input point
Reference to the next digital input point
Reference to the last possible digital input point
Used in Access Name
buscoupler rule
dep. on kind get DIPOBJ_
of connected VALUE
modules
Service Name
Get_Attribute_Single
0xFFFF(default): ConsumedConnectionSize
corresponds to the data width of the con-
nected output modules 0 – 32 ( PI_LIMIT ):
Fixed width of the ConsumedConnectionSize,
independent of the output modules.
PI_LIMIT – 0xFFFE: These values These
values cannot be set and led to fault messages.
The adjusted value become only on valid with
next switching.
UINT 0xFFFF
UINT
Defines configuration settings
Bit 0: =1 switches off global the announce-
ment of active diagnostic messages via the
MS LED. The diagnostic messages are trans-
ferred however further over the fieldbus. A
change of this attitude becomes only active
after a PowerOn cycle.
Bit 1..15 reserved.
Description
Used to read a DeviceNet Object attribute
value
Used to modify a DeviceNet object attribute
value
Data type Description
UINT Revision of the Discrete Input
Point Object, Range 1-65535, class
definition upon which the imple-
mentation is based.
UINT maximum number of instances of
an object currently created in this
class level of the device
Data type Description
BIT digital input bit
Description
Used to read an object attribute value.
WAGO-I/O-SYSTEM 750
Value
0x01
0x00ff
Value
0:off
1:on
DeviceNet