Specifications; General Specifications - Mitsubishi Electric GOT SIMPLE GS2110-WTBD User Manual

3. SPECIFICATIONS

3.1

General Specifications

Item
Operating ambient temperature
Storage ambient temperature
Operating/Storage ambient humidity
Vibration resistance
Shock resistance
Operating atmosphere
*1
Operating altitude
*2
Overvoltage category
*3
Pollution degree
Cooling method
Grounding
*1 Do not use or store the GOT under pressures higher than the atmospheric pressure of altitude 0m (0ft.). Failure to observe this
instruction may cause a malfunction. When the air inside the control panel is purged by pressurization, the surface sheet may be
lifted by high pressure. As a result, the touch panel may be difficult to press, and the sheet may be peeled off.
*2 This indicates the section of the power supply to which the equipment is assumed to be connected between the public electrical
power distribution network and the machinery within the premises. Category II applies to equipment for which electrical power is
supplied from fixed facilities. The surge voltage withstand level for up to the raged voltage of 300V is 2500V.
*3 This index indicates the degree to which conductive pollution is generated in the environment where the equipment is used. In
pollution degree 2, only non-conductive pollution occurs but temporary conductivity may be produced due to condensation.
0 to 50°C
-20 to 60°C
10 to 90%RH, non-condensing (The wet bulb temperature is 39°C)
When the ambient temperature exceeds 40°C, maintain the absolute humidity at 40°C and
90%.
Under
Conforms to intermittent
IEC 61131-2 vibration
Under
continuous
vibration
Conforms to IEC 61131-2 (147m/s
Must be free of lamp black, corrosive gas, flammable gas, or excessive amount of electro
conductive dust particles.
Must be no direct sunlight. (Same as for saving)
2000m (6562ft) max.
II or less
2 or less
Self-cooling
Class D grounding (100Ω or less), To be connected to the panel when grounding is not
possible.
Specifications
Frequency Acceleration
5 to 8.4Hz -
2
8.4 to 150Hz
9.8m/s
5 to 8.4Hz -
2
8.4 to 150Hz
4.9m/s
2
, 3times each in the X, Y, and Z directions)
3.1 General Specifications
Half
Sweep Count
amplitude
3.5mm 10times each
in X, Y and Z
-
directions
1.75mm
-
-
3 - 1
3