6.5
Installation Procedure
The GOT is designed to be embedded into a panel. Mount the GOT by following the procedure below.
Refer to "6.2 Panel Cutting Dimensions" for the panel cutting dimensions.
In addition, the thickness of the installation panel face must be 1.6 to 4mm.
6 - 4
6.5 Installation Procedure
Mounting hole
Mounting
fitting
Mounting
screw
POINT
POINT
POINT
Check that the packing is firmly attached with the GOT.
If the packing is loose, attach the packing to the GOT securely.
Step 1.
Inserting into the panel face
Insert the GOT from the front side of the panel.
Step 2.
Fixing the GOT
Engage the hook of the mounting fixture (accessory) to
the unit fixing hole of the GOT and fix them by tightening
the mounting screws (accessory) in the torque range of
·
0.36 to 0.48N
Step 3.
A protection film is attached on the display section of
GOT prior to shipment. Remove the film when the
installation is completed.
m.