16.3 FX3U-ENET-ADP Communication Setting Function
In GX Works2, the communication set value of the FX3U-ENET-ADP stored in the CPU can be changed.
This function is not available when the communication set value of the FX3U-ENET-ADP is not set in advance in the CPU.
16.3.1
Specifications
■1. System configuration
This section describes the system configuration of the FX3U-ENET-ADP communication setting function. For the setting
method in each connection form, used communication unit/cable and cautions on connection form, refer to the following
manual.
➠
■2. Required basic system application
Operating system
Basic system application
Communication driver
■3. Connection type
Name
FX3U-ENET-ADP communication
setting function
■4. Communication setting items
The table below shows the communication setting items and setting range.
Communication setting items
IP address
Subnet mask pattern
Default router IP address
*1
16 - 42
16.3 FX3U-ENET-ADP Communication Setting Function
POINT
POINT
POINT
Communication setting in the CPU
In GX Works2, set in advance the communication set value of the FX3U-ENET-ADP to the CPU.
For the details of the communication setting, refer to the following.
➠
FX3U-ENET-ADP User's manual
GOT2000 Series Connection Manual For GT Works3 Version1
MELSEC-FX
Function
The communication set value of the FX3U-ENET-ADP
stored in the CPU can be changed.
Setting range
0.0.0.1 to 223.255.255.254
*1
192.0.0.0 to 255.255.255.252
*1
0.0.0.1 to 223.255.255.254
Set the value "0.0.0.0" when not using the subnet mask pattern and default router IP address.
Version
-
-
( : Applicable, : Partly restricted, : Inapplicable)
Description
If a value outside the setting range is entered, the error
message "SET NUMBER IS INCORRECT." appears.
Connection type between GOT and controller
Direct CPU
GOT multidrop connection
connection
Remark