■2. Displays and key functions
The following describes the displays for the list monitor.
No.
Item
1)
List display area
2)
Keys
3)
[ ]
*1
16.2.18 Action for an incorrect key input
If an incorrect key is input, cancel the input contents.
■1. Operations
(1) Before touching the
Before touching the
(2) After touching the
Write the command again.
➠
Commands finalized by writing and inserting operations are revised (overwritten) with the program writing.
16 - 40
16.2 FX List Editor
1)
*1
The status of contacts and coils is displayed on the left of device displays.
The same operations as in the READ mode of the FX list editor can be executed.
➠
16.2.8 Displaying sequence programs
Ends the list monitor.
(When the list monitor is executed on the FX list editor screen, the screen is switched to the FX list
editor screen.)
The status of contacts and coils is displayed as below.
Type of instruction
LD, AND, OR (Contact instruction (Normal open))
LDI, ANI, ORI (Contact instruction (Normal close))
OUT, SET
RST
MC, STL
LDP, ANDP, ORP, LDF, ANDF, ORF
(Rise or fall contact instruction)
GO
key (before reading/writing the input contents)
GO
CLR
key, touch the
GO
key (after reading/writing the input contents)
15.3.10 Writing commands
Display contents
Description
Contact
Contact
TC: Coil
Except TC: Contact
TC: Reset
Word device
Except TC and word
device: Contact
Contact
Not monitored
key.
3)
2)
Status
■ Displayed
■ Not displayed
ON
OFF
OFF
ON
ON
OFF
ON
OFF
ON
OFF
Value: 0
Value: Except 0
OFF
ON
ON
OFF
Always ■ not displayed