12. DISPLAY AND OPERATION SETTINGS (GOT SET UP)
The setting screens related to the display or operation can be displayed from the utility screen.
In the setting screen for display and the setting screen for operation, the following settings can be set.
Item
Display settings
Operation settings
12.1 Display Settings
12.1.1
Display setting functions
Setting regarding display is possible.
The items which can be set are described below. If touch the each item part, the respective setting becomes possible.
Item
Opening time
Screen save time
Brightness
*1
Even if 0 is set, the title screen is still displayed. The title screen is always displayed for 4 seconds or more (depending on the
project data).
Setting the title display period and screen saving time
Brightness
Setting buzzer volume, window move buzzer, and key reaction speed
Touch panel calibration
Utility call key
Description
The title display period at the main unit boot can be set.
The period from the user stops the touch panel
operation till the screen save function starts can be set.
Brightness can be adjusted.
➠
■2. Brightness
POINT
POINT
POINT
(1) Display setting by GT Designer3
Set title display period, screen save time and screen save backlight by selecting [Common]
[GOT Environmental Setting]
When change a part of the setting, change the setting by the GOT display setting after
downloading the project data.
➠
GT Designer3 (GOT2000) Help
(2) Screen save time
By using the system information function, the screen save function can forcibly enabled from
a controller (Forced Screen Saver Disable Signal) or the screen saving time set in the utility
can be disabled (Automatic Screen Saver Disable Signal).
➠
GT Designer3 (GOT2000) Help
Description
0 to 60 seconds
(At factory shipment: 5 seconds)
0 to 60 minutes
(At factory shipment: 0 minute)
-
[GOT Setup] on GT Designer3.
12.1 Display Settings
Reference
➠
12.1.1
➠
12.2.3
➠
12.2.4
➠
12.2.5
Setting range
*2
12 - 1
12