Adapting The Display - Samson TROVIS 6495 Series Mounting And Operating Instructions

Return to the operating level
4x Return to the operating level.
9.3

Adapting the display

The display can be adapted in the following
ways:
4
Change controller display →
section 9.3.1
4
Set up additional display → sec-
tion 9.3.2
4
Switch Controller [1] and Controller [2]
displays → section 9.4
9.3.1 Changing the controller
display
The controller display is adapted in the
submenu C.5 Controller display of the
corresponding Controller [1] or [2] (1C.5 or
2C.5).
Signals can be selected for each row which
are to be displayed in the operating level.
The type of representation (numerical, bar
graph, etc.) can additionally be determined
for the rows 4 and 5.
The following table shows the settings neces-
sary for adapting the display (see section
15.2 for details).
Select signal
Row 1
C.5.1-1...4
Row 2
C.5.2-1...2
Row 3
C.5.3-1...3
Row 4
C.5.4-1...41
Row 5
C.5.6-1...41
Example: Based on the default setting (1x
fixed set point/follow-up controller M.1-1)
the output AO1 for Controller [1] in row 5 is
to be displayed as a bar graph.
According to the table above, the setting is
made in menu 1C Controller [1] in the
configuration items 1C.5.6 Row 5 and
1C.5.7 Row 5 representation.
The controller is currently in the operating
level:
4
Enter the configuration level, see sec-
tion 9.1.
Configure row 5
2x Select menu 1C Controller [1].
Configuration menu
Select type of
representation
–
–
–
C.5.5-1...6
C.5.7-1...6
33
EB 6495-2 EN