Configuration menu
The menu M Control mode is
highlighted.
9.2
Configuring the controller
The controller is configured by setting the
configuration items and associated parame-
ters.
Each configuration item has its own code,
which gives information on its position in the
configuration level.
Example: The configuration item Input
signal has the code I.1.1.
4
→ Menu I Input
I
4
I.1 → Submenu 1 Analog
input AI1
4
I.1.1 → Configuration item 1
Input signal with the setting -6
Pt 100
For control modes with two controllers, the
controller number "1C..." (Controller [1])
and "2C..." (Controller [2]) is added to dis-
tinguish between the controllers, e.g. for
30
EB 6495-2 EN
configuration item C.1.1.1 Input vari-
able PV:
Note: Some configuration items as well as
the parameters can only be set if certain set-
tings have already been made in the con-
troller configuration. The required settings
for the controller configuration are de-
scribed in the configuration list (section
15.2) and in the Configuration Manual
KH 6495-2 EN.
9.2.1 Setting configuration items
1. Read the code of the configuration item
that you want to change from the con-
figuration list (section 15.2).
2. Find the position in the configuration
level. See the example in section 9.2.2.
Select and set the configuration item
... If the configuration item that you
want to set is not in the menu
M Control mode, select the menu
required:
I Input
C Controller [1]/[2]
O Output
D Communication
A General settings