Operation
5.5.1
Adapting the Trend-Viewer
The standard graph shows the data measured at the outdoor sensor AF1 and flow sensor
VF1 plotted over time.
26
Note
− The additional information is hidden when the key number
1999 is entered again.
− The key number 1999 cannot be used to change the
controller configuration and parameterization. A separate
key number exists for configuration and parameterization
(see the 'Start-up' section).
¼ Open the Trend-Viewer.
Adding measuring data
q Select – – – – on the display.
¼ Activate editing mode for sensor selection.
q Select sensor.
¼ Confirm setting.
Deleting measured data:
q Select the sensor whose measured data are no longer to
be displayed.
¼ Activate editing mode for sensor.
q Select – – – – on the display.
¼ Confirm deletion.
KA 5578-E EN