Samson TROVIS 6495 Series Mounting And Operating Instructions page 121

AO2.P2 Y value for AO2 = AO2.MAX <O.2.3-1>
Y value for AO2 = AO2.MIN <O.2.3-2>
The default value of AO2.P2 is the same as AO2.MAX.
If AO2.MAX is changed, AO2.P2 is set to AO2.MAX.
O.2.4 Output ramp <O.2.1≠0, O.2.5-0>
Off
-0
Start with DI1
-1
Start with DI2
-2
Start with DI3
-3
Start with DI4
-4
AO2.GD Gradient <O.2.4≠0>
AO2.TB Time base <O.2.4≠0>
AO2.ST Initial value<O.2.4≠0>
O.2.5 Limit output rate <O.2.1≠0, O.2.4-0>
Off
-0
Increasing, continuously active
-1
Decreasing, continuously active
-2
Increasing and decreasing
-3
Increasing, start with DI1
-4
Increasing, start with DI2
-5
Increasing, start with DI3
-6
Increasing, start with DI4
-7
Decreasing, start with DI1
-8
Decreasing, start with DI2
-9
Decreasing, start with DI3
-10
Decreasing, start with DI4
-11
AO2.GD1 Gradient for increasing output signal
<O.2.5-1/-3/-4/-5/-6/-7>
AO2.GD2 Gradient for decreasing output signal
<O.2.5-2/-3/-8/-9/-10/-11>
AO2.TB2 Time base <O.2.5≠0>
O.2.6 Constant output value 1 with DI (auto mode) <O.2.1≠0>
Off
-0
With digital input DI1
-1
With digital input DI2
-2
With digital input DI3
-3
With digital input DI4
-4
AO2.K1 Constant output value 1 <O.2.6≠0>
Default
setting
[–10.0 ... 110.0 %] 100.0 %
O.2.4-0
[0.1 ... 100.0 %] 1.0 %
[s, min, h]
[–10.0 ... 110.0 %] 0.0 %
C.2.5-0
[0.1 ... 100.0 %] 1.0 %
[0.1 ... 100.0 %] 1.0 %
[s, min, h]
O.2.6-0
[–10.0 ... 110.0 %] 0.0 %
Appendix
Setting
s
s
121
EB 6495-2 EN