Panasonic Minas E Series Instruction Manual page 63

Copying parameters from console to servo driver (Copy Function)
Operations with Selection Display
Enter the copy mode by
S M
pressing once and
MODE
SET
times in the initial state of LED,
and then bring in
Operation with Execution Display
Reveal execution display
Keep pressing until the LED
display of the console is changed
to " ".
Reading parameters and model
code from EEPROM of console
starts.
Checking whether parameters
can be transmitted to servo
driver starts.
When the model code
read from console is
corresponded to the
model code of servo
driver.
Writing parameters into
EEPROM of servo driver starts.
After finishing copying, return to Selection Display referring to "Structure of Each Mode" (Page 48 and 49).
<Note>
Do not disconnect the console cable from the servo driver during the proceeding from
.
If the connector is disconnected during the time, wrong data will be written in and the data will be
crashed. In this occasion, copy the parameters from the copy source driver to the console, and then
copy the parameters from the console to the copy destination driver.
<Remarks>
If the error display appear repeatedly except for
cable, disconnection of connector, wrong operation due to noises, or failure of EEPROM of the console.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
five
When the model code
read from console is
different from the model
code of servo driver.
Copying has finished normally.
by pressing and
S
by pressing .
SET
Keeping pressing (about 3 seconds)
increases number of "
The number
decreases
over time as
10, 9, 8, ----.
<Note>
If this error display appears
By keeping pressing
during
(about 3 seconds),
value read from the console is
SHIFT
position of the decimal
out of range. In this occasion
check and modify the
point shifts to left as
parameters in the copy source
shown on the left.
driver, and then copy the
To cancel the copy,
parameters from the copy
S
press .
source driver to the console,
SET
and then copy the parameters
from the console to the copy
destination driver.
If this error display appears
except for
operation from the beginning
again.
To cancel the error, press
, that is presumably because of break of
63
[Preparations]
.
" as shown left.
Error display
, a parameter
, start the
to
S
.
SET