Panasonic Minas E Series Instruction Manual page 19

Part where DIN
rail is mounted
With rail stop
pushed in
DIN rail
Hook the upper side of DIN rail
mounting part on the DIN rail.
(4) Removing from DIN Rail
With the rail stop released, pull out the
lower part of the driver to the near side.
Mounting Direction and Space Requirements
• Allow enough space to ensure enough cooling.
• Install fans to provide a uniform distribution of temperature in the control box.
• Observe the environmental requirements for the control box, mentioned in the previous page.
Fan
Driver Exhaust
Direction
STATUS ALM CODE
x
6
x
5
min.
x 4
40 mm
x
3
x
1
Driver Intake
Direction
This driver has a cooling fan in its bottom and a mounting face.
To install the driver, ensure that there is enough space around the inlet and outlet ports so as not to prevent
intake and exhaust of the fans.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Press lightly.
Press lightly the lower part of
the main body of driver.
Pull out the lower part
of the driver to the
near side.
Driver Exhaust Driver Exhaust
Direction Direction
STATUS ALM CODE STATUS
x
6
x
5
min. min.
x 4
10 mm 10 mm
x
3
x
1
Driver Intake Driver Intake
Direction Direction
Ensure that the rail stop
has been pushed in.
Fan
Driver Exhaust
Direction
min.
100 mm
ALM CODE STATUS ALM CODE
x x
6 6
x x
5 5
min. min.
x 4 x 4
10 mm 40 mm
x x
3 3
x x
1 1
min.
100 mm
Driver Intake
Direction
19
[Before Use]
Driver mounted to DIN rail
By lifting the driver, you can remove it
from the DIN rail.