Panasonic Minas E Series Instruction Manual page 50

Using the Console
Example of Settings
MINAS
DIGITAL AC SERVO
M
MODE
SHIFT
S
SET
<Notes>
When the parameters that become active after they are reset have been changed,
completion of the write. Once turn off power for the console to reset them.
• If any data write error has occurred, write the data again. If the write error occurs repeatedly, the console may be
in failure.
• Do not turn off power while writing data into EEPROM. Otherwise, some false data may be written in the
EEPROM. If such an erroneous operation were made, setup all the parameters again, and after thoroughly
checking the settings, write the data again.
• Do not disconnect the console connector from the servo driver during the proceeding from
. If the connector is disconnected during the time by any chance, connect the connector again, and
restart the operation from the beginning.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
(1) Insert the connector of
console into CN X6 of the
driver, and then turn on the
power of the driver.
Setting parameters:
S
(2) Press .
SET
M
(3) Press .
MODE
(4) Select the parameter to be
set with and
S
(5) Press .
SET
(6) Change the value with
, and .
S
(7) Press .
SET
Starting EEPROM write:
M
(8) Press .
MODE
S
(9) Press .
SET
(10) Keep pressing (about
5 seconds). Then, the
number of bars increases
as shown on the right.
Start of write (indicated
momentarily.)
End
Write finishes.
After finishing write, return to Selection Display referring to
"Structure of Each Mode" (Page 48 and 49).
50
.
,
SHIFT
Write error occurs.
appears on
to