MISCELLANEOUS
ROLLERS
Fig. 7-7
The rear upper feed roller, the smooth roller A, should be protected from the
formation of rust on the surface. The entire surface should be lubricated with a thin
layer of oil if the machine is not in use for a period of more than one day.
CHAIN TIGHTENER FOR PICK-UP AUGER
Fig. 7-8
Two bolts A must be loosened to allow the eccentric B to be turned with a
screwdriver, etc. Turn in the + direction in order to tighten and in the – direction to
loosen.
CAUTION:
PIGB-206B-02 FCT 1260-1460 0218
7. MAINTENANCE
A
Fig. 7-7
Fig. 7-8
It should always be possible to move the chain at least 20 mm
up and down in the middle in order to avoid over-tightening.
- 95 -