Table of Contents
Advertisement
The auger on the pick-up is equipped with a slip clutch. The slip clutch of the auger is
adjusted so that it releases before the other friction clutches in the machine.
The highest capacity is obtained by operating at a forward speed where you drive
without causing blockages in the auger. If there is a blockage around the auger, stop
and force the crop out of the machine by using the reverse function. See also section
"6 OPERATION IN THE FIELD".
A continuous and even flow through the pick-up and auger is the best way to avoid
blockages inside the machine, which can lead to long operational stoppages.
The operator should always have spare friction discs for the slip clutch on the auger
are kept in the tractor. If this clutch has been in operation for a considerable period,
the coating on the friction discs will become worn and will be unable to transmit
sufficient torque. It may therefore be necessary to replace the friction discs, but
remember these must be of the same quantity and quality.
CHANGE OF SPEED OF PICK-UP TINES
Extra sprockets and chains are supplied in order to be able to change the speed of
the pick-up tines. This is an option that permits optimisation of material harvesting.
The stated speeds are the tines' peripheral speed on the ground with the maximum
cutting length.
2064-720x
2065-897x (Standard)
2065-994x
Fig. 4-3
This is sprocket A, which is replaceable.
PIGB-206B-02 FCT 1260-1460 0218
Sprocket no.
Fig. 4-3
4. SETTINGS
Number of
teeth Z
21
25
30
- 47 -
Speed
10 km/h
12 km/h
14 km/h
A
Advertisement
Table of Contents
