Table of Contents
Advertisement
ROTOR AND ROLLER SECTION
Fig. 4-15
Fig. 4-15 The distance A between the blades of the rotor and the shearbar must be checked
regularly using the gauge supplied (distance measuring device). A distance of 0.5
mm should be aimed for. If it is necessary to adjust the distance, loosen the two
bearing housings B and adjust using the screws C. When the distance has been
checked, tighten the bolts D of the bearing housings using a torque wrench to 40
kgm (400 Nm).
The machine is equipped with a scraper for the smooth roller E. The scraper is fitted
together with the reversible shearbar previously mentioned.
The scraper is placed as close to the smooth roller E as possible without touching it.
Therefore, the distance between the scraper and the smooth roller should be
between 0.2 and 0.5 mm. Then tighten the bolts F using a torque wrench to 10-12
kgm (100-120 Nm). Incorrect adjustment of the scraper may result in
overheating of the smooth roller and an operational stoppage.
PIGB-206B-02 FCT 1260-1460 0218
4. SETTINGS
- 54 -
Advertisement
Table of Contents
