Transport - Kongskilde FCT 1260 Operator's Manual

TRANSPORT

Limit the transport speed to a maximum of 30km/h if the machine is not marked with
a different maximum permitted speed.
Once the machine has been prepared for transport, the control unit must be turned
off using the button on the side of the control box, and/or the oil supply to the
machine must be disconnected. This prevents faulty operation during transport. If the
machine has been fitted with an LS kit, the control unit for this must be turned off.
DANGER:
The machine is fitted with equipment for hydraulic conversion into the transport
position, and the cylinder for this is fitted a hose rupture valve. If there is air in the
cylinder during transport, there is a risk that the machine may drift into the opposite
lane or onto cycle lanes or in towards pavements.
IMPORTANT: If the machine is fitted with an auto-hitch, the mechanical lock on the
IMPORTANT: Test all hydraulic cylinders following coupling to the tractor in order to
The attachments for the forage harvester (pick-up, etc.) must be secured
mechanically prior to transport.
The statutory requirements concerning lights and traffic safety marking must be
positioned correctly, and any trailers attached must also be checked in addition to the
forage harvester.
Reflectors and lighting must be cleaned regularly.
PIGB-206B-02 FCT 1260-1460 0218
1. INTRODUCTION
Never allow anyone to climb or ride on the machine.
auto-hitch must be activated when driving while towing a trailer on
public roads. This also applies in cases where a hose rupture valve
has been fitted to the lifting cylinder of the auto-hitch.
remove any air in the oil. This is particularly applicable when driving
on public roads.
- 15 -