FRICTION CLUTCH
There is an integral friction clutch on the PTO drive shaft between the drawbar and
the gearbox, which ensures that the machine is not overloaded during operation.
The clutch must be "vented" before you start a new machine. See section concerning
the friction clutch in chapter 7 "MAINTENANCE".
WIDE-ANGLE PTO SHAFT
If the machine is supplied with a wide-angle PTO shaft, it must also be supplied with
an extension to the drawbar.
You must fit the wide-angle PTO shaft to the machine and the tractor before fitting
the extension. The tractor must be positioned directly in front of the drawbar so that
the PTO shaft is not at an angle, with the PTO shaft extruding between 125 and 175
mm.
Fig. 2-14 The height of the machine is adjusted using the support leg, so that the PTO shaft is
horizontal.
PIGB-206B-02 FCT 1260-1460 0218
2. CONNECTING TO THE TRACTOR
Fig. 2-14
- 34 -