Table of Contents
Advertisement
DRAWBAR AND PTO DRIVE SHAFT
The hitch eye of the drawbar is intended for a 30 mm hitch pin. The hitch pin must be
secured.
The drawbar load is around 700 kg depending on equipment.
STANDARD PTO SHAFT
The machine can be supplied with a standard PTO shaft and a wide-angle shaft. This
section relates to the fitting of a standard PTO shaft. The subsequent section relates
to a wide-angle shaft.
Fig. 2-11 Adjust the length of the PTO shaft so that:
- The operating position has minimum overlap of 200 mm, see measurement b.
- Under no circumstances should the shaft be closer to the block than 30 mm, see
measurement a.
The length may be adjusted both by pulling out or pushing in the drawbar of the
tractor.
PIGB-206B-02 FCT 1260-1460 0218
2. CONNECTING TO THE TRACTOR
Fig. 2-11
- 31 -
Advertisement
Table of Contents
