FOLLOWING OPERATION
You must always bring the reverse system into neutral position when you have
finished working. This slackens the V-belts on the V-belt drive.
MISCELLANEOUS
If you use ensiling agents, the relevant safety instructions for these must be
observed.
It is particularly important to use eye protection.
WORKING POSITIONS
The position of the drawbar may be continuously adjusted using the hydraulic
cylinder on the side of this. In order to avoid obstacles, etc. in the field, it is possible
to freely adjust the position of the drawbar during operation due to the fact that the
drawbar goes above the pick-up
The wide pick-up width of the machine allows the forage harvester to be operated in
several positions in relation to the tractor:
Fig. 6-9
1) The forage harvester collects grass at the side of the tractor, i.e. offset. This
allows a single wide swath or two double swaths to be collected, which is very
well suited to the forage harvester. This is a very good operating technique when
the crop is to be loaded into a trailer on the right hand side of the forage
harvester.
PIGB-206B-02 FCT 1260-1460 0218
6. OPERATION IN THE FIELD
Fig. 6-9
- 84 -