Md Control - Kongskilde FCT 1260 Operator's Manual

MD CONTROL

Fig. 5-5 The control unit A located under the left rear guard contains the necessary controls
for the metal detector It receives a signal from the magnetic tub, and in cases where
magnetic metal is detected, it sends a signal to the coil to block the feed intake and
to the reverse function to switch to the neutral position. It also verifies whether the
feed intake has reversed via the magnetically operated switch. The metal detector is
active when the machine is started and requires reversing before it can operate
normally. See Chapter 6 "Starting in the field".
The metal detector turns on each time the control unit is switched on.
Fig. 5-6 When the control unit is switched on and the metal detector is on, the two control
lights on the MD control unit and the light on the control box will be illuminated.
PIGB-206B-02 FCT 1260-1460 0218
5. METAL DETECTOR (MD)
Fig. 5-5
Fig. 5-6
- 73 -