Fct 1260 - Kongskilde FCT 1260 Operator's Manual

FCT 1260

Fig. 4-35 The tensioning of the V-belt also takes place automatically. This is determined by the
compression spring A. The tensioning of the V-belt may be altered by turning nut B
on the spindle of the compression spring until the spring has the correct length:
WARNING:
PIGB-206B-02 FCT 1260-1460 0218
4. SETTINGS
Fig. 4-35
 The length must be 450 mm for a long cutting length of 15/21
mm.
 The length must be 430 mm for a short cutting length of 9/13 mm.
These lengths apply to the reverse function for the "feed intake".
The spring tensioning must NOT be increased beyond the
amounts specified, as this may overload the transmission. The
belt drive acts as a belt coupling, and will slip in the event of the
overloading of the feed intake section.
This coupling function allows observant operators to change
gear when the belts begin to slip, and thereby avoid a blockage
in the feed intake section.
(430 mm)
450 mm
A B
- 66 -