Table of Contents
Advertisement
GRINDING
Always follow this procedure when switching to or from grinding:
Unfortunately, it is necessary to remove some of the guards to change the direction
of rotation of the rotor when grinding the blades. As there are chain and belt
transmissions, your hands may be injured if the rotating parts have not stopped
before the guards are removed.
Grinding is performed using the following procedure:
1.
Check to make sure that the grindstone is free from damage and that the device
can move backwards and forwards easily.
2.
Lower the guard behind the grinding device to give free access to the blade
cylinder.
3.
Adjust the stone before replacing the guard on the grinding device.
4.
Remove the guard above the blade cylinder transmission and change the
direction of rotation of the rotor.
5.
Close the guard again and check that no one is near the machine.
6.
Start the tractor again and keep the RPM either at idling speed or slightly
above.
7.
Perform the grinding carefully.
Always use safety glasses when grinding, as small particles may fly off the
grindstone.
Following grinding, stop the tractor engine again, remove the ignition key, change the
direction of rotation and fasten all guards.
REMEMBER: Always grind with all guards closed.
PIGB-206B-02 FCT 1260-1460 0218
1. INTRODUCTION
- Stop the tractor engine and remove the ignition key;
- Activate the parking brake;
- Wait until all moving parts have stopped.
- 17 -
Advertisement
Table of Contents
