Table of Contents
Advertisement
REVERSING
The reverse function can be used at full RPM (1,000 RPM on the PTO), but we
recommend you decrease the RPM to reduce the strain on the machine as much
as possible and reduce the wear of the rubber disc.
Fig. 4-34 The overlap between the steel friction disk B and the rubber disk C is 5±3 mm during
reversing. This must not be adjusted for wear because the cylinder always maintains
a constant pressure determined by the pressure relief valve.
CAUTION:
PIGB-206B-02 FCT 1260-1460 0218
4. SETTINGS
B
Fig. 4-34
Only use the reverse function for a short period of time on each
occasion to ensure the correct functioning and long life of the
rubber disc.
- 65 -
C
Advertisement
Table of Contents
