Harvesting gear, FCT 1260MD and FCT 1460MD
Fig. 8-3
The oil status is checked using the sight glass. The correct position of the gearbox is
neutral for checking and topping up the oil.
Oil change: After the first 10 operating hours and annually thereafter.
LUBRICATING WHEEL HUBS
Disassemble the wheel hubs.
Clean the hubs thoroughly inside and out.
Carefully clean and inspect both of the wheel bearings.
Refill new grease.
Grease the wheel bearings with a 10 mm thick layer of grease.
After fitting and adjusting the play of the wheel bearings (see Chapter 7:
MAINTENANCE) fill the hubcaps 3/4 full of grease and refit.
PIGB-206B-02 FCT 1260-1460 0218
8. LUBRICATION
Fig. 8-3
- 107 -
Oil content
Quality
10-11 l
80W-90