Adjustment Of Hydraulic Flow - Kongskilde FCT 1260 Operator's Manual

ADJUSTMENT OF HYDRAULIC FLOW

The machine may be fitted with a hydraulic block allowing the adjustment of the flow
to the deflector and drawbar.
Fig. 2-2 The adjustment screws A are used to adjust the speed at the drawbar. The
adjustment screws B are used to adjust the deflector. The machine is supplied from
the factory with the flow adjusted to the recommended rate. Slacken the nuts and
turn the adjustment screws to change this. Tighten the nuts again when you are
happy with the level of adjustment.
IMPORTANT:
PIGB-206B-02 FCT 1260-1460 0218
2. CONNECTING TO THE TRACTOR
A
B
Fig. 2-2
It is possible to adjust the screw to such an extent that the function
works in the opposite way. Unscrew the adjustment screw again until
the function works correctly if this occurs.
B
- 25 -
A