Normal Start And Stop Procedure - Kohler SFGLD480 Operation & Maintenance Manual

5. Post-lubricate the engine during five minutes after shut-down (when fitted with a pre-lube/post-lubrication
system),
The exhaust pipe must be blocked off when the engine is shut down for long periods of time, to prevent
rainwater or condensation from getting into the engine should be exposed to these elements.

4 NORMAL START AND STOP PROCEDURE

During normal operation, the start-up procedure shall be as follows:
1. Start the engine with both the ignition system and the fuel supply off, in order to eliminate any residual
fuel from the intake and exhaust lines.
2. First turn the ignition system on and next the fuel supply.
During normal operation, the shut-down procedure shall be as follows:
1. Turn the fuel supply to the engine off.
2. Allow the engine to turn over several times and then disconnect the ignition system. Any residual fuel will
get out of the system or will burn in the cylinders before the ignition system is off.
5 EMERGENCY START AND SHUT-DOWN
In case of an emergency, shut down the engine by turning the fuel supply and ignition system off at the same
time. Failure to comply with this rule may lead to irreparable damage, injury or death.
CAUTION
Before restarting the engine after an emergency shutdown, wait for 10 minutes until the engine
temperatures have stabilised. Do not restart the engine, unless the causes of the shutdown have been
completely identified and the problems solved. Failing to do this may lead to irreparable damage, injury or
death. Once the problems have been identified and solved, you can restart the engine according to the
normal start-up procedure described in point 4.
PRODUCT INFORMATION
IO-G-T-00-003e
STARTING AND STOPPING OF EMERGENCY GAS ENGINES
4.1.42
INDEX DATE
September 2014
O&M_2.002211.810_A_10_2016
Dep. 2
4/4