1. INTRODUCTION
Once the display has been properly connected in accordance with the guidelines set out in IM-G-C-33-004, it is
then ready for use.
This document lists the steps required to configure the display and also sets out the different features provided:
data visualization, parameter settings.
2. DISPLAY CONFIGURATION
Configuration is divided into two steps:
-
In order to connect the ignition unit to the display, first you have to configure the unit.
-
Screen configuration
For both steps, you have to access the Device Menu display
2.1. DEVICE CONFIGURATION
To configure the devices you wish to view, you have to access the Device Setup menu within the Device Menu
view via the display.
The steps for including data related to the GIS ignition unit on the display are outlined below:
1. Clicking the Add New button displays the following window shown in Figure 2
PRODUCT INFORMATION
IO-G-M-33-010e
INSTALLATION AND OPERATION MANUAL - GIS IGNITION UNIT
Fig. 1 – Screenshot of Device
Menu
4.1.25
INDEX
DATE
June 2013
DISPLAY
O&M_2.002211.810_A_10_2016
Dep. 2
1/14