Room Monitoring - TIPTEL Ergophone C User Manual

Extended telephone functions

Room monitoring

You can monitor a room where your telephone is located - remotely.
The function „room monitoring" has to be activated at the telephone in the
room to be monitored (see page 40 of the programming instructions).
Tone dialling must be set at the telephone from which you intend to monitor
the room. Pick-up the handset and dial the telephone number. The telephone
in the room to be monitored rings once and engages the line. Enter the four-
digit access code (see page 41 of the programming instructions).
Afterwards, the device switches to the monitoring mode and you can listen to
what is happening in the surroundings, i. e. monitor the room. If you wish to
have a „silent monitoring" without the earlier ringing signal, you just need to
deactivate the ringing signal (see page 22 of the programming instructions).
You can change from the monitoring mode to the hands-free mode or "two-
way-communication" by pressing the following keys at your telephone.
When using the „silent monitoring", please observe the Data Protection Law.
Handsfree mode is activated.
"Two-way-communication": You hear the person in the
monitored room.
"Two-way-communication": You speak.
You can switch back and forth by pressing the keys 4 and
6.
„Replace the handset". The connection is disconnected.
In the monitored room, no busy tones are heard via the
loudspeaker.
You can end the room monitoring function by replacing the
handset or pressing key 8.
29