Chapter 4 Element Management System (EMS)
To configure the trap destination:
1. Right-click the requested device and select
The Device Properties dialog displays.
2. Select the
3. On the Communications tab, click
The Trap Destination / Add dialog displays.
4. Fill the following fields in the Trap Destination – Add dialog.
IP Address – Sets the IP address of the trap destination
❑
UDP Port – Sets the UDP port number of the trap destination
❑
Description – Optional parameter, describing the trap destination
❑
Trap Community – Set the trap community
❑
5. Click
OK
6. Click
Apply
© 2011 Harmonic Inc.
Figure 4–19: Device Properties dialog – Communications tab
tab.
Communications
.
.
on the context menu.
Properties
.
Add...
89
Element Properties Configuration
ProView 7000 v.2.4, Rev. A