Harmonic ProView 7000 User Manual page 29

Chapter 3 Configuration and Monitoring
f Select
g Navigate
h Set the Admin Status to Up.
i Navigate
Traffic Parameters
j Configure the IP Address Type, UDP Port and IP Address if you are using Multicast.
k Navigate
l Configure the Socket De-Jittering Mode, SSM and Socket Admin Status.
3. If the output stream is sent to IP, perform the following to configure a GbE output port:
a Navigate
b Set the GbE mode to
The device reboots.
c Navigate
d Configure the IP Address, Subnet Mask and Default Gateway.
e Select
f Select
g Navigate
h Set the Admin Status to Up.
i Navigate
j Configure the Destination IP Address and the Destination UDP Port.
k Set the Socket Status to Up.
4. If you wish to descramble, you must associate the CAM to the multiplex:
a Navigate
b Select a multiplex, TS1, TS2, TS3 or TS4.
The descrambling mode default is Selective, you can change the mode to Full.
5. To access the CAM MMI menu, select
6. Select a DVB-S/S2 input port:
a Navigate
b Select an input port for the received transport stream (Options: SAT (1–4), ASI (1–4)).
7. Select
Input Type
the output stream.
NOTE: The default option for stream type is DVB. For ATSC systems, set the stream type to MPEG.
8. To configure the multiplex output:
a Navigate
b Select one or more outputs for the received transport stream (Options: ASI (1–2),
Socket (1–4).) The four sockets are virtual and must be associated to a physical GbE
port.
c Select
© 2011 Harmonic Inc.
.
Apply Changes
Root > GbE > GbE Port (1 or 2) > Admin Status
Root > GbE > Socket Configuration > Socket In > Socket (no.) >
.
Root > GbE > Socket Configuration > Socket In > Socket (no.)
Root > Unit > GbE Mode (In/Out)
.
Out
Root > GbE > GbE Port (1 or 2) > IP Configuration.
.
Apply Port Changes
.
Apply Changes
Root > GbE > GbE Port (1 or 2) > Admin Status
Root > GbE > Socket Configuration > Socket Out > Socket (no.)
Root > CAM > CAM (1 or 2) > CAM Association
Root > Routing and Descrambling > TS (no.) > Input Selection
, (Options: MPEG and DVB). This also sets the respective PSI/SI tables for
Root > Routing and Descrambling > TS (no.) > Output Selection
in each output sub-menu that you select.
Enable
How to Configure and Monitor the ProView 7000
.
.
.
.
.
CAM MMI
29
.
.
.
.
ProView 7000 v.2.4, Rev. A