Advantech ADAM-5000/TCP Series Manual page 140

Planning Your Application Program
$aaSiER
Name
Description
Syntax
Response
ADAM-5000/TCP User's Manual
Initialize EEPROM data
Initializes all EEPROM data in a specified analog in-
put module to their default values. This command is
sent following a failed attempt to calibrate a module
(the module shows no effect from an attempted cali-
bration). Following initialization, the problem mod-
ule should readily accept calibration.
$aaSiER(cr)
$ is a delimiter character.
aa (range 00-FF) represents the 2-character hexadeci-
mal Modbus network address of the ADAM-5000/
TCP system. Si identifies the I/O slot for which you
wish to initial- ize all EEPROM data. ER is Initialize
all EEPROM data command.
(cr) is the terminating character, carriage return (0Dh)
!aa(cr) if the command is valid.
?aa(cr) if an invalid operation was entered. There is
no response if the module detects a syntax error or
communication error or if the specified ad- dress
does not exist.
! delimiter character indicating a valid command was
received.
? delimiter character indicating the command was
invalid.
aa (range 00-FF) represents the 2-character hexadeci-
mal Modbus address of an ADAM-5000/TCP sys-
tem.
(cr) is the terminating character, carriage return (0Dh
Chapter 6
6-73