Microscan MS-615 User Manual page 48

Chapter 2 Menu Configuration
UPC
Status
Default: Disabled
Options: Disabled, Enabled
When enabled, the scanner will read UPC version A and UPC version E only.
EAN
Default: Disabled
Options: Disabled, Enabled
Note: UPC must be enabled for EAN to take effect.
When EAN is enabled, the scanner will read UPC version A, UPC version
E, EAN 13, and EAN 8. It will also append a leading zero to UPC version A
label information and transmit 13 digits. If you do not want to transmit 13
digits when reading UPC version A labels, disable EAN.
Supplementals
Default: Disabled
Options: Disabled, Enabled, Required
Note: Supplementals is set to Enabled, Triggering Mode (page 2-11) must not
be set to Continuous Read 1 Output.
Allows the scanner to read supplemental bar code data that has been
appended to the standard UPC or EAN codes.
When set to Required, the scanner treats the supplemental data and the
bar code label as a single label. Also, supplemental data must be found or a
noread will result.
When set to Enabled, the scanner treats the supplemental data and the bar
code label as separate labels.
Separator
Default: Disabled
Options: Disabled, Enabled
Allows you to insert a character between the standard UPC or EAN code
and the supplemental code.
Separator (character)
Default: , (comma)
Options: Any ASCII character.
Allows you to change the separator character from a comma to a new value.
2-24
MS-610 Scanner User's Manual