User Outputs Menu; Figure 2-8 User Outputs Menu Structure - Microscan MS-615 User Manual

Chapter 2 Menu Configuration

User Outputs Menu

The User Outputs menu allows you to control the external (video or audio)
outputs that identify scanning conditions.
To help visualize the menu's organization and to locate the page number
where each topic is described, see figure 2-8 on page 2-26.
Beeper Status
Default: On Good
Options: On Good, On Noread, Disabled
A beep is emitted either after each good read of a bar code label or after
each noread.
Note: The beep period will be short for triggered modes where a new trigger
occurs immediately or the output is delayed to the end of the read cycle on edge
and serial triggers.
User Outputs
(page 2-26)
Beeper
Status
On Good
–
On Noread
–
Disabled
–
(page 2-28)
Clock
Speed
Slow
–
Fast
–
* Divide the number entered on the command line by 100 for time in seconds.
2-26
MS-610 Scanner User's Manual
Bold text represents default settings.
–
(page 2-27) (page (page 2-27)
2-27)
Beeper Full
Beeper
Volume Screens
Speed
Level 4 Enabled
– –
Level 5 Fast Disabled
–
– –
Slow
Level 1
–
–
Level 2
–
Level 3
–
(page 2-16) (page 2-29)
(page 2-29)
Relay Driver Relay
Relay Pulse Width
Polarity (in 10 ms incs) *
Good Read
–
Noread
– Positive
50 ms
–
–
Match
– Negative
User Definable
– –
Mismatch (0 to 255)
–
Mismatch or
–
Noread

Figure 2-8 User Outputs Menu Structure

(page 2-27) (page 2-27)
New Master Laser
Pin On/Off
Disabled Disabled
– –
Enabled Enabled
– –
(page 2-29)
Command
Start
Character
<
–
User
–
Definable
(ASCII char.)