Microscan MS-615 User Manual page 102

Index
Skew 1-9, A-3
Software Part Number (display) 4-5
Software Reset 4-3
Spaces (as characters) 2-4
Specifications A-2–A-4
Specular Reflection 1-9
Start & Stop Match
by menu selection 2-20, 2-22
by serial command 3-10
Start & Stop Output
by menu selection 2-20, 2-22
by serial command 3-10
Status LED A-4
Status Lights A-4
Status Operational Commands 4-5
Stop Bits A-2
by menu selection 2-5, 2-9
by serial command 3-7
Supplementals
by menu selection 2-20, 2-24
by serial command 3-11
System Setup 1-2
T
Terminal Communications 2-1
Test Operational Commands 4-5
See Read Rate Test
Test.
Tilt 1-9
Timeout & New Trigger
by menu selection 2-11, 2-14
by serial command 3-8
Timeout (end of read cycle option)
by menu selection 2-11, 2-14
by serial command 3-8
Timeout in 10 ms incs
by menu selection 2-11, 2-15
by serial command 3-8
Trigger Counter Commands 4-4
Trigger Filter Timing Value 3-4
Triggering Mode
by menu selection 2-11, 2-11–2-13
by serial command 3-8
I-6
MS-650 Scanner User's Manua
Troubleshooting
operational tips 1-15
table A-9–A-10
U
Universal Stand A-12
UPC/EAN
by serial command 3-11
definition A-13
EAN (by menu selection) 2-20, 2-24
UPC (by menu selection) 2-20, 2-24
User Defined
by menu selection 2-5, 2-7
by serial command 3-5
User Defined Multidrop
by menu selection 2-5, 2-7
by serial command 3-5
User Outputs
by menu selection 2-26–2-29
by serial command 3-12–3-13
menu structure 2-26
See also Beeper, Beeper Volume,
Beeper Speed, Full Screens,
New Master Pin, Laser On/Off,
Clock Speed, Relay Driver, Re-
lay Polarity, Relay Pulse Width,
Command Start Character
W
Warning Summary vii
Warranty Information ii
When to Output
by menu selection 2-11, 2-16
by serial command 3-9
l