Front Pto Shaft - Zetor MAJOR CL Operator's Manual

Front PTO shaft

Front PTO shaft is equipped with a solid six or twenty-one
splined end point and it comes only in design of 1,000
revolutions.
Tractor may be equipped with front PTO shaft with varied
direction of spinning:
a - In compliance with the direction of engine
revolutions (standard)
b - Against the direction of engine revolutions
(*on request)
Activation of the front PTO shaft - common working mode
When the tractor is going or is not going with its engine running:
A - The operator must sit on the driver's seat.
B - Press the button on the panel of the instrument panel to activate the front PTO shaft.
The operator must sit on the driver's seat when pressing the button.
C - Activation of the front PTO shaft is indicated with the activated symbol on the switch of the front PTO
shaft and the symbol on the display of the instrument panel.
If the operator, when working with the front PTO shaft in
the common working mode, leaves the driver's seat, an
audio signal is generated, the warning symbol appears on
the display of the instrument panel and the front PTO shaft
is stopped.
During the period when the warning symbol is
displayed on the display of the instrument panel, the
front PTO shaft does not rotate even if the switch of
the front PTO shaft and the symbol on this switch are
activated.
To reactivate the front PTO shaft, you must sit on the
driver's seat, switch off and then switch on the switch of
the front PTO shaft on the panel of the instrument panel.
DRIVE OF AGRICULTURAL MACHINERY
MCL18N031
66
NM15D066
MCL18N010