Chrysler Concorde 2004 Service Manual page 1117

LEFT FRONT SENSOR CIRCUIT FAILURE —
TEST
5 Turn the ignition off.
Disconnect the CAB harness connector.
Disconnect the affected Wheel Speed Sensor connector.
Connect a jumper wire between affected Wheel Speed Sensor 12 Volt Supply circuit
and ground.
Using a 12-volt test light connected to 12-volts, probe the affected Wheel Speed
Sensor 12 Volt Supply circuit.
Does the test light illuminate?
Yes → Go To 6
No
6 Turn the ignition off.
Disconnect the affected Wheel Speed Sensor connector.
NOTE: Check connector - Clean/repair as necessary.
Turn the ignition on.
Measure the voltage between affected Wheel Speed Sensor Signal circuit and ground.
Is the voltage above 1 volt?
Yes → Repair the affected Wheel Speed Sensor Signal circuit for a short
No
7 Turn the ignition off.
Disconnect the CAB harness connector.
Disconnect the affected Wheel Speed Sensor connector.
Using a 12-volt test light connected to 12-volts, probe the affected Wheel Speed
Sensor Signal circuit.
Does the test light illuminate?
Yes → Repair the affected Wheel Speed Sensor Signal circuit for a short
No
8 Turn the ignition off.
Disconnect the CAB harness connector.
Disconnect the affected Wheel Speed Sensor connector.
Connect a jumper wire between affected Wheel Speed Sensor Signal circuit and
ground.
Using a 12-volt test light connected to 12-volts, probe the affected Wheel Speed
Sensor Signal circuit.
Does the test light illuminate?
Yes → Go To 9
No
ACTION
→ Repair the affected Wheel Speed Sensor 12 Volt Supply circuit for
an open.
Perform ABS VERIFICATION TEST - VER 1.
to voltage.
Perform ABS VERIFICATION TEST - VER 1.
→ Go To 7
to ground.
Perform ABS VERIFICATION TEST - VER 1.
→ Go To 8
→ Repair the affected Wheel Speed Sensor Signal circuit for an open.
Perform ABS VERIFICATION TEST - VER 1.
Continued
21
BRAKES (CAB)
APPLICABILITY
All
All
All
All