Chrysler Concorde 2004 Service Manual page 1111

CAB INTERNAL FAILURE —
TEST
3 Turn the ignition off.
Disconnect the CAB harness connector.
Using a 12-volt test light connected to 12-volts, probe the CAB harness connector
ground circuits.
Did the test light illuminate?
Yes → Go To 4
→ Repair the CAB Ground circuit for an open.
No
4 Turn the ignition off.
Using a 12-volt test light connected to ground, probe the ABS Valve Fused B(+) circuit
at the CAB harness connector.
Did the test light illuminate?
Yes → Go To 5
→ Repair the ABS Valve Fused B(+) circuit for an open.
No
5 Turn the ignition off.
Using a 12-volt test light connected to ground, probe the ABS Pump Fused B(+)
circuit at the CAB harness connector.
Did the test light illuminate?
Yes → Replace the Controller Antilock Brake in accordance with the
→ Repair the ABS Pump Fused B(+) circuit for an open.
No
6 Turn the ignition off.
Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or
partially broken wires.
Visually inspect the related wire harness connectors. Look for broken, bent, pushed
out, or corroded terminals.
Refer to any Hotline letters or Technical Service Bulletins that may apply.
Were any problems found?
Yes → Repair as necessary.
→ Test Complete.
No
Continued
ACTION
Perform ABS VERIFICATION TEST - VER 1.
Perform ABS VERIFICATION TEST - VER 1.
Service Information.
Perform ABS VERIFICATION TEST - VER 1.
Perform ABS VERIFICATION TEST - VER 1.
Perform ABS VERIFICATION TEST - VER 1.
15
BRAKES (CAB)
APPLICABILITY
All
All
All
All