Chrysler Concorde 2004 Service Manual page 1183

LR -Low/reverse Clutch or Pressure
Switch
LU -Lockup
MIC -Mechanical Instrument Cluster
MIL -Malfunction Indicator Lamp
NGC Next Generation Controller
OBDII -On Board Diagnostics
OD -Overdrive Clutch or Pressure
Switch
OSS -Output Speed Sensor
PCM -Powertrain Control Module
PEMCC -Partial Electronically Modulated
Converter Clutch
PLU -Partial Lockup
REV -Reverse Clutch
SLPK -Solenoid Pack
SSV -Solenoid Switch Valve
SW -Switch
TCC -Torque Converter Clutch
TCM -Transmission Control Module
TP -Throttle Position
TRD -Torque Reduction
TRS -Transmission Range Sensor
UD -Underdrive Clutch
2/4 -2nd and 4th gear Clutch or Pres-
sure Switch
GENERAL INFORMATION
6.2 DEFINITIONS
OBDII (EURO STAGE III OBD) Trip - A vehicle
start and drive cycle such that all once per trip
diagnostic monitors have run.
Key Start - A vehicle start and run cycle of at least
20 seconds.
Warm-up Cycle - A vehicle start and run cycle
such that the engine coolant must rise to at least
71°C (160°F) and must rise by at least 4.4°C (40°F)
from initial start up. To count as a warm-up cycle,
no DTC may occur during the cycle.
23