Subaru Legacy 2005 Service Manual page 2816

CLUTCH SYSTEM
5. Operating Cylinder
A: REMOVAL
1) Remove the air intake chamber. (Non-turbo
model) <Ref. to IN(H4SO 2.0)-7, REMOVAL, Air In-
take Chamber.>
2) Remove the intercooler. (Turbo model) <Ref. to
IN(H4DOTC)-12, REMOVAL, Intercooler.>
3) Disconnect the clutch hose from operating cylin-
der.
CAUTION:
Cover the hose joint to prevent clutch fluid from
flowing out.
• 5MT model
(A)
(B)
(A) Clutch hose
(B) Operating cylinder
• 6MT model
(B)
(A) Clutch hose
(B) Operating cylinder
Operating Cylinder
4) Remove the operating cylinder from transmis-
sion.
• 5MT model
• 6MT model
CL-00252
B: INSTALLATION
1. 5MT MODEL
1) Install in the reverse order of removal.
NOTE:
Before installing the operating cylinder, apply
grease (KOPR-KOTE: Part No. 003603001) to the
contact point of release lever and operating cylin-
der.
Tightening torque:
(A)
CL-00209
2) After bleeding air from the operating cylinder,
ensure that clutch operates properly.
<Ref. to CL-34, Clutch Fluid Air Bleeding.>
CL-26
(A) Operating cylinder
⋅
T1: 18 N m (1.8 kgf-m, 13.0 ft-lb)
⋅
T2: 37 N m (3.8 kgf-m, 27.5 ft-lb)
T2
T1
T2
CL-00253
(A)
CL-00210
CL-00254