Table of Contents
Advertisement
B: INSTALLATION
1) Install the differential assembly into clutch hous-
ing.
2) Apply gear oil to the threaded portion of side re-
tainer.
3) Remove the O-ring from side retainer of both
side.
4) Using the ST, install the differential side retainer
to both side.
ST1 499787000
WRENCH ASSY (RH SIDE)
ST2 18630AA000 WRENCH ASSY (LH SIDE)
NOTE:
Be careful not to damage the oil seal.
(B)
(A)
(A) LH side
(B) RH side
5) Check and adjust the hypoid gear backlash.
<Ref. to 6MT-107, HYPOID GEAR BACKLASH,
INSPECTION, Front Differential Assembly.>
6) Check and adjust the tooth contact. <Ref. to
6MT-99, ADJUSTMENT, Drive Pinion Shaft As-
sembly.>
Front Differential Assembly
ST1
ST2
MT-00657
6MT-103
MANUAL TRANSMISSION AND DIFFERENTIAL
7) Put marks on the engagement position of the
right and left side retainer and clutch housing.
8) Remove the differential side retainer from both
side.
NOTE:
Record the rotating number of time till removal,
when removing the side retainer.
9) Install the O-ring to retainer on both side.
NOTE:
Always use a new O-ring.
10) Install the differential side retainer to both side.
NOTE:
Install the side retainer by screwing in the same ro-
tating number of time till removal, and then align
the marks.
11) Install the lock plate.
Tightening torque:
⋅
25 N
m (2.5 kgf-m, 18.4 ft-lb)
NOTE:
Be careful not to confuse right and left lock plate.
(A)
(A) LH
(B) RH
12) Completely remove the remaining liquid gasket
from the clutch housing and adapter plate.
MT-00658
(B)
MT-00659
Advertisement
Chapters
Table of Contents
