Subaru Legacy 2005 Service Manual page 2766

MANUAL TRANSMISSION AND DIFFERENTIAL
13) Apply liquid gasket to the clutch housing.
Liquid gasket:
THREE BOND 1215 (Part No. 004403007)
14) Install the drive pinion shaft assembly. <Ref. to
6MT-96, INSTALLATION, Drive Pinion Shaft As-
sembly.>
15) Install each gear assembly at a time. <Ref. to
6MT-70, INSTALLATION, Main Shaft Assembly.>
16) Install the transmission case. <Ref. to 6MT-65,
INSTALLATION, Transmission Case.>
17) Install the oil pump. <Ref. to 6MT-62, INSTAL-
LATION, Oil Pump.>
18) Install the center differential. <Ref. to 6MT-60,
INSTALLATION, Center Differential.>
19) Install the transfer driven gear. <Ref. to 6MT-
58, INSTALLATION, Transfer Driven Gear.>
20) Install the extension case. <Ref. to 6MT-47, IN-
STALLATION, Extension Case.>
21) Install the oil pipe, neutral position switch,
back-up light switch and harness. <Ref. to 6MT-42,
INSTALLATION, Oil Pipe.> <Ref. to 6MT-45, IN-
STALLATION, Neutral Position Switch.> <Ref. to
6MT-43, INSTALLATION, Back-up Light Switch.>
22) Install the manual transmission assembly into
vehicle. <Ref. to 6MT-36, INSTALLATION, Manual
Transmission Assembly.>
C: DISASSEMBLY
1. DIFFERENTIAL CASE
1) Secure the differential assembly on a vise, then
remove the hypoid driven gear.
Front Differential Assembly
2) Using the ST, drive out the straight pin from dif-
ferential assembly toward hypoid driven gear side.
ST 899904100
MT-00532
3) Pull out the pinion shaft, and remove the bevel
pinion gear and bevel gear and washer.
4) Using the ST, remove the hypoid driven gear
side bearing.
ST 399527700
MT-00660
6MT-104
REMOVER
(D)
(A) (C)
(A) Pinion shaft
(B) Bevel pinion gear
(C) Bevel gear
(D) Washer
PULLER SET
ST
ST
MT-00661
(B)
(C)
(D)
(B)
MT-00662
MT-00663