Subaru Legacy 2005 Service Manual page 2786

MANUAL TRANSMISSION AND DIFFERENTIAL
25.Clutch Housing
A: REMOVAL
1) Remove the manual transmission assembly
from vehicle. <Ref. to 6MT-34, REMOVAL, Manual
Transmission Assembly.>
2) Prepare the transmission for overhaul. <Ref. to
6MT-40, Preparation for Overhaul.>
3) Remove the oil pipe, neutral position switch,
back-up light switch and harness. <Ref. to 6MT-42,
REMOVAL, Oil Pipe.> <Ref. to 6MT-45, REMOV-
AL, Neutral Position Switch.> <Ref. to 6MT-43, RE-
MOVAL, Back-up Light Switch.>
4) Remove the extension case. <Ref. to 6MT-47,
REMOVAL, Extension Case.>
5) Remove the transfer driven gear. <Ref. to 6MT-
58, REMOVAL, Transfer Driven Gear.>
6) Remove the center differential. <Ref. to 6MT-60,
REMOVAL, Center Differential.>
7) Remove the oil pump. <Ref. to 6MT-61, RE-
MOVAL, Oil Pump.>
8) Remove the transmission case. <Ref. to 6MT-
64, REMOVAL, Transmission Case.>
9) Remove each gear assembly. <Ref. to 6MT-69,
REMOVAL, Main Shaft Assembly.>
10) Remove the drive pinion shaft assembly. <Ref.
to 6MT-96, REMOVAL, Drive Pinion Shaft Assem-
bly.>
11) Remove the front differential assembly. <Ref.
to 6MT-102, REMOVAL, Front Differential Assem-
bly.>
B: INSTALLATION
1) Install the pitching stopper bracket.
Tightening torque:
⋅
41 N m (4.2 kgf-m, 30.2 ft-lb)
2) Install the front differential assembly. <Ref. to
6MT-103, INSTALLATION, Front Differential As-
sembly.>
3) Install the drive pinion shaft assembly. <Ref. to
6MT-96, INSTALLATION, Drive Pinion Shaft As-
sembly.>
4) Install each gear assembly at a time. <Ref. to
6MT-70, INSTALLATION, Main Shaft Assembly.>
5) Install the transmission case. <Ref. to 6MT-65,
INSTALLATION, Transmission Case.>
6) Install the oil pump. <Ref. to 6MT-62, INSTAL-
LATION, Oil Pump.>
7) Install the center differential. <Ref. to 6MT-60,
INSTALLATION, Center Differential.>
8) Install the transfer driven gear. <Ref. to 6MT-58,
INSTALLATION, Transfer Driven Gear.>
9) Install the extension case. <Ref. to 6MT-47, IN-
STALLATION, Extension Case.>
10) Install the oil pipe, neutral position switch,
back-up light switch and harness. <Ref. to 6MT-42,
Clutch Housing
INSTALLATION, Oil Pipe.> <Ref. to 6MT-45, IN-
STALLATION, Neutral Position Switch.> <Ref. to
6MT-43, INSTALLATION, Back-up Light Switch.>
11) Install the manual transmission assembly into
vehicle. <Ref. to 6MT-36, INSTALLATION, Manual
Transmission Assembly.>
C: DISASSEMBLY
1) Remove the clutch release bearing guide.
2) Remove the oil seal.
ST 398527700
NOTE:
Use a new oil seal.
ST
6MT-124
MT-00717
PULLER ASSY
MT-00718