Table of Contents
Advertisement
MANUAL TRANSMISSION AND DIFFERENTIAL
(1) Shift the 1st-2nd sleeve to 1st driven gear
side, then press down to the stopper and mea-
sure "B1".
(B)
(A)
(A) 1st driven gear
(B) 1st-2nd sleeve
NOTE:
• Set the indicator of height gauge near measuring
object, then lock the dial (1) as shown in the figure.
Turn dial (2) to set the indicator to edge surface of
sleeve 1st side.
• Measure five points of the sleeve turning every
approx. 72°. Round off each two upper and lower
measurement value. Use the remaining middle val-
ue as measurement value.
(2) Set the height gauge indicator upside down.
(A)
(A) Indicator
Shifter Fork and Rod
MT-00702
(2)
(1)
MT-00585
MT-00703
6MT-116
(3) Shift the 1st-2nd sleeve to 2nd driven gear
side, then press down to the stopper and mea-
sure "B2".
(A) 2nd driven gear
(B) 1st-2nd sleeve
NOTE:
• Set the indicator of height gauge near measuring
object, then lock the dial (1) as shown in the figure.
Turn dial (2) to set the indicator to edge surface of
sleeve 2nd side.
• Perform the measuring procedure with two peo-
ple, and measure the sleeve lifted up straight.
• Measure five points of the sleeve turning every
approx. 72°. Round off each two upper and lower
measurement value. Use the remaining middle val-
ue as measurement value.
(A)
(B)
MT-00704
(2)
(1)
MT-00585
Advertisement
Chapters
Table of Contents
