Table of Contents
Advertisement
2. 6MT MODEL
1) Install in the reverse order of removal.
NOTE:
Before installing the operating cylinder, apply
grease (SUNLIGHT 2: Part No. 003602010) to the
contact point of release lever and operating cylin-
der.
Tightening torque:
⋅
T1: 18 N
m (1.8 kgf-m, 13.0 ft-lb)
⋅
T2: 41 N
m (4.2 kgf-m, 30.2 ft-lb)
NOTE:
• Be sure to install the clutch hose with the mark-
ing side facing upward.
• Be careful not to twist the clutch hose during in-
stallation.
(C)
(A) Marking
(B) Clutch hose
(C) Operating cylinder
2) After bleeding air from the operating cylinder,
ensure that clutch operates properly.
<Ref. to CL-34, Clutch Fluid Air Bleeding.>
C: INSPECTION
1) Check the operating cylinder for damage. If op-
erating cylinder is damaged, replace it.
2) Check for fluid leakage or damaged boot on the
operating cylinder. If any leakage or damage is
found, replace the operating cylinder.
Operating Cylinder
T1
T2
CL-00211
(A)
(B)
CL-00041
CL-27
CLUTCH SYSTEM
Advertisement
Chapters
Table of Contents
