Table of Contents
Advertisement
6) Put marks on the engagement position of the
right and left side retainer and clutch housing.
7) Return the side retainer LH for three teeth, and
screw in the side retainer RH for three teeth.
8) Using the ST, secure the drive pinion shaft.
ST 18621AA000 ADAPTER WRENCH
9) Install the SUBARU genuine axle shaft to front
differential LH and RH.
Parts No. 38415AA000 AXLE SHAFT
10) After rotating the drive pinion shaft several
times, measure the hypoid gear backlash using the
ST.
ST1 498255400
PLATE
ST2 498247001
MAGNET BASE
ST3 498247100
DIAL GAUGE
Hypoid gear backlash:
0.13 — 0.18 mm (0.0051 — 0.0071 in)
11) If the backlash is out of specification, adjust it
by turning the right and left side retainers.
12) Screw in the side retainer of RH side for more
than 1.75 teeth.
Front Differential Assembly
3. TOOTH CONTACT OF HYPOID GEAR
Refer to the section of drive pinion for checking of
tooth contact. <Ref. to 6MT-107, TOOTH CON-
TACT OF HYPOID GEAR, INSPECTION, Front
Differential Assembly.>
MT-00658
ST
MT-00674
MT-00675
6MT-109
MANUAL TRANSMISSION AND DIFFERENTIAL
Advertisement
Chapters
Table of Contents
