NEC Electra Elite IPK II General Description Manual page 109

Electra Elite IPK II
S e l e c t a b l e R i n g T o n e s
An extension user can change the way trunks or internal calls ring their telephone.
Selectable Ring Tones allow an extension user to set up unique ringing for their calls.
This is important in a crowded work area where several telephones are close
together. Because their telephone has a characteristic ring, the user always can tell
when it's their telephone ringing.
S e r i a l C a l l
Serial Call is a method of transferring a call so it automatically returns to the
transferring extension. Serial Calling saves transferring steps between users. For
example, a Customer Service Representative (CSR) has a client on the telephone
who needs technical advice. The CSR wants to send the call to Technical Service,
but needs to advise the client of certain costs when Technical Service is done.
Rather than transferring the call back and forth, the CSR can use Serial Call to
Technical Service and announce, "I have Ted on the telephone. I need to talk to him
again. Just hang up when you're done and I'll get him back."
S i n g l e L i n e T e l e p h o n e s , A n a l o g 5 0 0 / 2 5 0 0 S e t s
The system is compatible with 500 type (Dial Pulse) and 2500 type (DTMF) analog
single line telephones (SLTs). You can install single line telephones as On-Premise or
Off-Premise extensions. Single line telephone users can dial codes to access many of
the features available to multiline terminal users. With Single Line Telephones, you
can have your system simulate PBX type operation.
There are 256 single line telephones available (note that this number may be
restricted due to system power requirements).
When installing single line telephones you must have:
J
J
CODEC Filter Data Setup Program Added
When Program 82-07-01 CODEC Filter Setup for Analog Station Ports is set to "4 -
Specified Data", the system will use the settings in Program 82-09 SLIU CODEC
Filter Data Setup.
These values should not be changed from their default settings unless directed by
NEC'S Technical Service department.
The side tone of the SLIU is adjusted using all 16 values, however, special software is required in order
to compute these values. The setting is not proportional to the gain level. To change these values,
contact National Technical Assistance Center (NTAC) for assistance.
General Description Manual
A port on an SLIU ETU for each single line telephone installed.
(If you have 2500 sets) At least one block reserved on the CPUII for analog
extension DTMF reception.
Document Revision 1
2 - 63