NEC Electra Elite IPK II General Description Manual page 13

Electra Elite IPK II Document Revision 1
INDUSTRY CANADA REQUIREMENTS
Industry Canada has established rules that permit this telephone system to be directly connected to the
telephone network. Prior to the connection or disconnection of this telephone system to or from the
telephone network, the telephone company must be provided with the following information.
1. Your telephone number.
2. IC registration number: 140 7942 A
3. Ringer Equivalence Number (REN) of the equipment: 2.1
The Industry Canada label identifies certified equipment. This certification means that the equipment
meets certain telecommunications network protective, operational and safety requirements as
prescribed in the applicable Terminal Equipment Technical Requirements document(s). The Department
does not guarantee that equipment operates to the user satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the
facilities of the local telecommunications company. The equipment must also be installed using an
acceptable method of connection. The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative designated by the supplier.
Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the
telecommunications company cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility,
telephone lines and internal metallic water pipe system, When present, are connected together. This
precaution may be particularly important in rural areas.
CAUTION
Users should not attempt to make such connections themselves, but should contact the applicable
electric inspection authority or electrician.
The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication of the
maximum number of terminals allowed to be connected to a telephone interface. The termination of an
interface may consist of any combination of devices subject only to the requirement that the sum of the
Ringer Equivalent Numbers of all the devices does not exceed five.
This equipment has been listed by the Canadian Standards Association and found to comply with all
applicable requirements of the standard for telephone equipment C 22.2 No. 225.
This equipment meets IC requirements CS03.
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus
as set out in the radio interference regulations of Industry Canada.
Regulatory R-5